Trough rolling forming machine (rolling machine) is an important metal processing equipment, its use matters are very important to ensure the safety of operation and improve production efficiency. The following are the precautions about the use of the groove rolling forming machine:
Do a detailed inspection before using the trench rolling molding machine. The pipe mouth to be processed should be smooth and have no burr, the weld inside the welded pipe should be ground flat, and the rough oxide layer and dirt on the inner and outer surface of the pipe end should also be cleaned up. At the same time, check whether the power supply meets the requirements, to prevent damage to the motor due to leakage phase shortage, and ensure that the hydraulic oil is enough, the machine can not work in the state of oil shortage.
The operation process shall be standardized. Place the bracket according to the length of the steel pipe, place one end of the steel pipe on the roller and one end on the bracket. The bracket position should be placed two thirds of the total length of the steel pipe from the roller end, and the height of the bracket should be adjusted to the level of both ends of the steel pipe or the bracket end slightly lower one degree to ensure the stability of the steel pipe during the roller. When adjusting the depth and pressing the groove, strictly follow the operating procedures to avoid excessive or insufficient pressure groove.
Safety always comes first. The power supply of the roller shall be grounded. Ensure that the power supply voltage matches the rated voltage of the roller before use. When the roller machine is working, it is strictly prohibited to put your hand into the pipe end, or contact the running parts such as the roller and pressure wheel. Operators should wear protective equipment to ensure their own safety.
In addition, regular maintenance and maintenance of the groove rolling forming machine is also essential. This includes inspection of each parts, maintenance of lubricating oil, dust removal, etc. to ensure normal operation and extend service life.
In short, following the above precautions, we can ensure the safe and efficient use of the groove rolling molding machine.