The operation mode of the metal plate rolling forming machine
Rolling forming machine for metal plates is an efficient and accurate metal processing equipment, widely used in automobile, construction, home appliances and other industries. The following is the basic operation mode of rolling forming machine for metal plates:
1. Equipment preparation
Before operation, it is necessary to ensure that the equipment has been correctly installed and fixed, and the horizontal and vertical level adjustment is in place. At the same time, check the electrical circuit of the equipment to ensure that there is no abnormality, then connect the power supply for empty test, observe whether the equipment runs smoothly, and stop immediately to check if there is any abnormal sound.
2. Mold installation
Select the appropriate mold according to the processing requirements and install it on the equipment. The mold installation should be firm to avoid loosening or falling off during rolling.
3. Material placement and adjustment
The metal plate to be processed is placed in the mold, and the guiding mechanism and feeding mechanism are adjusted to ensure that the metal plate can smoothly enter the rolling area. At the same time, the R value of the workpiece is adjusted according to the processing requirements to achieve the expected forming effect.
Rolling forming
Start the equipment, and the metal plate is pushed into the rolling area by the feeding mechanism. After continuous rolling by multiple rollers, it gradually forms the required shape. During the rolling process, pay close attention to the operation status of the equipment. If abnormal vibration, hydraulic oil leakage or noise problems are found, stop the machine immediately for inspection.
5. Cut off the discharge
After the rolling molding is completed, the equipment will automatically cut the formed metal plate from the mold with hydraulic fixed length. At this time, the operator needs to clean up the debris around the equipment in time and keep the working area clean.
6. Shutdown and maintenance
After the work is over, the power supply of the equipment should be turned off and the equipment should be cleaned and maintained as necessary to extend the service life of the equipment. At the same time, the operation record of the equipment should be filled in for subsequent maintenance and management.