The main motor and oil pump motor of cold-formed steel equipment should be filled or replaced with lubricating grease for the front and rear bearings every six months according to the maintenance requirements of the motor;
All bearings of the unit are running at low speed, so No. 3 calcium-based grease is used for lubrication. It should be checked and added every six months, and should be cleaned and replaced once a year.
The transmission chain and sprocket of cold-formed steel equipment also run at low speed, so it is enough to add L-ckc-150 gear oil once every half month.
Chains and sprockets should be cleaned regularly. That is to remove the sludge and dirt on it to prolong the service life. When cleaning, remove the sprocket cover. After cleaning, refill the lubricating oil and install the sprocket cover.
Before starting the cold-formed steel equipment, be sure to fill the cycloidal pinwheel reducer with L-ckc-150 gear oil to the position indicated by the oil mark. Usually pay attention to check, do not make the fuel tank short of fuel;
The gear oil in the gearbox should be replaced once a year.