In order to ensure the safety of the cold-formed steel machine operation, a special person should cooperate with the forklift driver to carry out the material loading, so that the steel coil material and the expansion and contraction reel shaft are consistent, and then the forklift driver gradually puts the steel coil material on the trolley.
The operator needs to raise or lower, adjust the steel coil material to the middle of the expansion and contraction reel shaft, and adjust the movable bearing seat at the top of the uncoiler to keep it on the same level as the uncoiler.
Adjust the expansion nut to make the four bow-shaped plates and expand the coil material to prevent deformation and damage of the coil material during operation. This is the only way to be fool-proof and complete tasks on time. Of course, in addition to the operation of the cold forming machine, its maintenance is also crucial.
The main motor and oil pump motor of the cold-formed steel machine should be filled with or replaced the lubricating grease of the front and rear bearings every six months according to the maintenance requirements of the motor. smooth. It should be checked and increased every six months, and it should be cleaned and replaced once a year.
The transmission chain and sprocket of the cold-formed steel machine are also running at low speed, so it is enough to add L-ckc-150 gear oil every half month. Chains and sprockets should be cleaned regularly. That is to remove the sludge and dirt on it to extend the service life, remove the sprocket cover when cleaning, after cleaning, refill the lubricating oil, and then install the sprocket cover.
Before starting the cold-formed steel machine, be sure to fill L-ckc-150 gear oil in the cycloidal pinwheel reduction box to the position indicated by the oil mark. Usually pay attention to check, do not make the oil tank short of oil; the gear oil in the reduction box should be replaced once a year.