The actual operation requirements of the cold-formed steel machine: Before adjustment, check that the cold-formed steel equipment motor will adjust the steam pressure to ten meters Pato, and the test run will be about 3 minutes. If you feel that there is no problem, you can officially start your work. Equipment and equipment installations must be sturdy and stable. Change the oil and gear oil on time before application.
Appropriate application of cold-formed steel equipment, in accordance with practical operating standards and safety practical operating standards. If there is no oil in the fuel tank of the car, damage to the motor should be avoided. The oil in the car's gas tank should be presumed that the oil shortage should increase over time. The lubrication of the equipment should be maintained in a stable condition and should be maintained regularly. If the equipment and equipment are not used for a long time, anti-rust treatment should be carried out in advance to prevent rust.
Generally speaking, it is a general cold-formed steel equipment. In the whole process of operation, multi-system software must cooperate to successfully carry out the door fixing bracket of its auxiliary system software, and the automatic hot-rolled strip in the middle of the steel can be successfully carried out. steel. The hydraulic transmission system allows the hydraulic cylinder tail groove and cold-drawn roll cold-rolled steel to turn off the hydraulic transmission system when the design plan stipulates that the electric isolation. It is geared to start and push the steel forward.
Then it turned cold again. Compared with the traditional press processing technology, this type of cold drawing processing technology has the advantages of environmental protection, energy saving, low noise, high efficiency and high efficiency.