3731 Maintenance Techniques for Profile Forming Machine - China Roll Forming Machine, Steel Water Tank Machine, Steel Silo Rollformer, Suppliers, Manufacturers, Factory - J&R
news

Maintenance Techniques for Profile Forming Machine

2023-06-26
1. Regularly inspect the components, 1-2 times a month, and check whether the movable parts such as worm gear, worm gear, bearings, pressure wheels, crankshaft, upper and lower rail guides rotate flexibly and wear. If defects are found, they should be repaired and used in a timely manner.

2. After a single use or shutdown, the remaining powder should be removed and the remaining powder should be brushed off from all parts of the machine. If the shutdown time is long, all the stamping dies must be removed and the machine must be wiped clean. The smooth surface of the machine parts should be coated with anti rust oil and covered with a cloth.

3. The maintenance of the stamping die should be placed inside the box, so that all the stamping dies can penetrate into the oil, and should be kept clean to avoid rust and scratches. It is best to customize the box to be packed in one box of each specification to avoid incorrect installation and help to grasp the damage situation during use.

4. The place of use should be regularly cleaned, especially for pharmaceutical and edible tablet manufacturing, where there should be no dust or dust present.

5. Electrical components should be maintained, inspected regularly, and maintained in good working condition. The cooling fan should regularly use compressed air to remove accumulated dust.

6. Electrical components should pay attention to the working environment conditions (temperature, humidity), and in a good environment, the service life of the components will be extended.

7. The maintenance of electrical components should be carried out by professional technical personnel, especially the frequency converter, and should be carried out with care. Generally, it should be sent to a professional manufacturer for repair.

8. Before conducting insulation tests on the electrical components of the machine, all the control wires of the main circuit of the frequency converter must be removed to prevent damage to the frequency converter during the insulation test. The insulation test method for the frequency converter can be found in the frequency converter operation manual.