Self-locking roof panel rolling forming machine is an efficient and automatic roof panel processing equipment. Here is its use method:
Preparation: check whether all parts of the equipment are normal, such as whether the lubricating oil is sufficient and whether the screws are loose. At the same time, prepare the right amount of raw materials, to ensure the smooth production.
Start up: Press the start button, and the feeding will start after the equipment runs smoothly. Note that the feeding amount should be moderate, to avoid too much or too little.
Operation: according to the production demand, adjust the parameters of the equipment, such as pressure, temperature, speed, etc. Ensure that the parameters are set reasonably to ensure that the produced roof panels are qualified. At the same time, to pay close attention to the running state of the equipment, if abnormal, should stop in time for inspection.
Inspection: After the completion of each batch, part of the finished products should be inspected to check whether the size, appearance and mechanical properties meet the standards. If there is any problem, the equipment parameters should be adjusted in time to ensure the product quality.
Shutdown: After production, shut down and clean the equipment and surrounding environment. For the equipment that is not used for a long time, it should be maintained regularly.
Safety precautions: Wear safety protective equipment, such as gloves, masks, etc. during operation; never repair and maintain the equipment during operation.
The correct use of self-locking roof panel rolling molding machine can not only improve the production efficiency, but also ensure the product quality and operation safety. For more information, it is recommended to consult a mechanical engineering expert or consult relevant teaching videos.