131 Operation process and precautions of the second-floor beam rolling forming machine - China Roll Forming Machine, Steel Water Tank Machine, Steel Silo Rollformer, Suppliers, Manufacturers, Factory - J&R
news

Operation process and precautions of the second-floor beam rolling forming machine

2024-11-25

The operation process of the second beam rolling forming machine mainly includes the following steps:

Preparation: Check whether the parts of the machine are in good condition and confirm that the power supply and air pressure system are normal.

Material placement: Place the pretreated steel at the inlet of the machine to ensure that the material is straight and aligned with the equipment.

Start equipment: turn on power, adjust control parameters such as speed, pressure, etc. to meet different materials and molding requirements.

Rolling molding: the material is gradually deformed through the roller to reach the predetermined section shape and size.

Cutting material: the formed beam is cut through the cutting device.

Finished product output: remove the formed second floor beam from the machine for subsequent processing.

matters need attention:

Operators must be familiar with the machine operating procedures and safety precautions.

Wear the necessary protective equipment, such as safety helmet, protective glasses, earplugs, etc., before the operation.

Check the wear condition of the machine regularly, and replace the badly worn parts in time.

Ensure the quality of the material to avoid poor forming effect or equipment damage due to material problems.

Never extend your hands or other parts of the body into the machine during the operation.

After the molding machine stops using, the machine should be cleaned in time to keep the equipment clean and extend the service life.