The operation steps of the adjustable cable tray rolling machine are as follows:
Check the equipment: confirm that all parts of the coil machine are intact, the power cord is correctly connected, and the lubrication system is normal.
Set parameters: adjust the bending angle and speed of the machine according to the specification of the cable bridge.
Prepare materials: Place the cable tray on the bench of the comachine to ensure its correct position.
Open the equipment: start the plate rolling machine and observe whether the equipment runs smoothly.
Bending: adjust the remachine slowly according to the set parameters to gradually bend the cable tray to the desired shape.
Check the bending quality: during the bending process, check the shape and quality of the cable bridge at any time, and adjust it timely if there is any problem.
Complete bending: When the cable tray bends to the required shape, stop the equipment and remove the finished product.
Clean the table: after the operation, clean the table and keep the equipment clean.
Close the equipment: confirm that the coil machine stops running, turn off the power supply and end the operation.