41 Operation mode of the roof panel forming machine - China Roll Forming Machine, Steel Water Tank Machine, Steel Silo Rollformer, Suppliers, Manufacturers, Factory - J&R
news

Operation mode of the roof panel forming machine

2024-11-29

The roof panel forming machine is an automation equipment used for the production of the roof panel, operated as follows:

First, make sure that the equipment is installed on a smooth ground, and the power supply is connected. Then, follow these steps below:

Check the equipment: Before starting, check whether all parts of the roof panel molding machine are in good condition, such as conveyor belt, pressure plate, cutting device, etc., to ensure that there is no damage or loosening.

Preparation materials: prepare the corresponding specifications, color coated steel plate or aluminum magnesium manganese alloy plate according to the production requirements.

Set parameters: according to the size and shape requirements of the roof panel, adjust the parameters of the equipment, such as molding mold, cutting length, etc.

Start the device: press the start button and the device starts running. At this time, the operation of the equipment should be closely observed to ensure the smooth production process.

Feed: place the prepared material on the conveyor belt, pay attention to keep the material flat, and avoid wrinkles or deformation.

Forming: When the material passes through the molding mold, it will be subjected to pressure and tensile force, thus forming the wave shape of the roof panel.

Cutting: The formed roof panel is cut through a cutting device to obtain the desired length of the roof panel.

Cutting: After cutting, remove the roof panel from the conveyor belt and pile it in the designated area.

Stop equipment: After the production is completed, press the stop button to stop the equipment. Turn off the power supply, clean up the equipment, and do the routine maintenance work well.

Check the finished products: check the produced roof panels to ensure that the size and shape meet the requirements.

In short, the operation of the roof panel forming machine mainly includes checking equipment, preparing materials, setting parameters, starting equipment, feeding, forming, cutting, cutting, stopping equipment, inspection of finished products and other links. In the actual operation process, the equipment operation procedures should be strictly followed to ensure the production safety and product quality.