The operation process of the roof panel rolling forming machine mainly includes the following steps:
Before operation, first ensure that the operator is familiar with the performance and operating procedures of the machine. Before starting, it is necessary to check whether there are sundries or obstacles around the rolling forming machine and it, and ensure that all moving parts have enough lubricating oil, and lubricating oil also needs to be applied on the sliding surface. In addition, it is necessary to check whether the instrument and button are normal, and confirm the test run of the equipment, usually for 10 minutes, to fully lubricate each lubrication point, and it is strictly prohibited to start with load.
After the preparation is completed, the height, width and compaction force of the roller should be adjusted to ensure that these parameters are set reasonably to meet the requirements of the current processing roof panels. Then, select the speed and pressing force suitable for the current profile, if not enough, can be fine-tuning. During the whole work process, the locked handle must be locked to prevent displacement. If any obstacle or abnormality is found in the work, it must stop immediately and continue the operation after troubleshooting.
In the process of rolling and forming, the operator should stick to the work post, and shall not leave without authorization. When you need to leave, you need to stop and explain the equipment situation to the monitor. During the operation, pay close attention to the operating condition of the equipment. If there is abnormal vibration, hydraulic oil leakage or noise, immediately stop for inspection. After the end of the work, pull the power cut to ensure that the equipment is in a safe state, and clean the sanitation around the equipment.
Through the above steps, we can ensure the safe and efficient operation of the roof panel rolling forming machine, and provide a strong guarantee for the production of high-quality roof panel.