Common problems should be ensured very well in advance before the application of the cold forming machine. Below is a brief introduction, what are the key points of general attention?
First, before use, be sure to choose a flat cabinet table for placement to ensure that the equipment is stable, and then open the main box feet for easy inspection. Then insert the power plug into the control panel and turn it tightly. Next, the power plug at one end is inserted into the control panel behind the main box, and the other end is inserted into the switching power supply, and it is stipulated that a single-phase three-wire switching power supply is generally used, and then the power switch behind the main box is turned on. Carry out the actual operation in a certain way, and adjust it to a certain value. Afterwards, until the emerald green indicator light is on, and there is a reminder sound, the next work is just beginning to seal the work, and then check the quality of the seal, and carry out actual operations according to different materials to ensure the seal. The quality is guaranteed to be the best.
Mandatory maintenance of cold-rolled forming machines is very important: excellent maintenance of all industrial equipment is a very important step to increase the service life. From the perspective of the entire application cycle time of cold-rolled forming machines, application, maintenance, and repair account for The vast majority of the total service life of the cold forming machine also ensures that the cold forming machine can give full play to its practical value.
The cold-rolled forming machine has a large list of construction works, complicated daily tasks, high project investment, fast construction period and strong periodicity. Mandatory maintenance of the cold-rolled forming machine is very necessary. critical for equipment in harsh environments. According to the general analysis of common faults, 56% of the cold forming machines are all based on the problems caused by fearful maintenance, 38% are due to on-time maintenance errors, and 6% are caused by wrong operations. A bending machine is a must.
Why should the cold drawing equipment do a good job of lubricating: Lubrication can be intermittent lubricating and sustainable lubricating according to time. According to daily maintenance, if the equipment does not work, you only need to replace it once every six months. Oil is fine, but if the equipment is in operation, the second and third lubricating time periods should be between 20 and 30 days. When the equipment is running, pay attention to whether the fuel injector is out of oil when the main shaft bearing is running. If there is a common fault, the maintenance should be terminated immediately. And if the fuel tank of the car is not cleaned and tidy, no other oil or remanufactured oil can be used to prevent damage to the rolling bearing. All in all, the operation of a piece of equipment is carried out by the mutual cooperation of several components, so doing a good job in the usual lubricating work is also to make the cold-drawing forming equipment work better, so as to improve the work efficiency. , reducing the quality time.