In order to better ensure the safety factor of cold-formed steel equipment, in the case of feeding, full-time personnel should cooperate with forklift drivers to maintain consistency between the steel coil material and the expansion and contraction wire rope reel shaft, and then the forklift driver gradually Roll the material onto the car. The operator needs to raise or lower, adjust the steel coil material to the middle of the expansion and contraction wire rope reel shaft, at this time, adjust the movable belt seat bearing on the top of the uncoiler to keep it at the same level as the uncoiler.
Adjust the expansion nut to make the four bow plates and expand the steel coil material to avoid deformation and damage of the steel coil material during work. That's the only way to be sure that nothing goes wrong and that the goal is reached on time. Naturally, apart from the actual operation of the equipment, its maintenance is also particularly important.
The main motor and gasoline pump motor of the cold-formed steel equipment should be filled or replaced with the smooth grease of the front and rear, left and right rolling bearings once every six months according to the maintenance regulations of the motor. Calcium based glossy grease develops glossy finish. It should be checked and upgraded once every six months, and it should be cleaned and replaced once a year.
The transmission gears and sprockets of the cold-formed steel equipment are also all running in low gears, so it is enough to fill the oil every half month. Drive chains and sprockets should be cleaned on time. That is to remove the grease and waste on the top to extend the service life of the application. Remove the sprocket cover when cleaning. After cleaning, refill the clean oil from the beginning, and then install the sprocket cover.
Before starting the cold-formed steel equipment, it is necessary to fill the oil in the reducer of the cycloid reducer to the direction indicated by the oil level gauge. Usually pay attention to the inquiry, do not make the car fuel tank less oil; the oil in the reducer should be replaced once a year.