The operation mode of the trench forming machine is relatively simple and efficient. Here are the detailed operation steps:
1. Preparation stage
Before operation, ensure that the machine is in good working condition. Check the stability of the metal frame, the normal operation of the power system, the wear of the excavated parts, and the sensitivity of the control system. At the same time, to ensure that the equipment of fuel oil, lubricating oil, hydraulic oil and other sufficient.
2. Site layout
According to the construction drawings, use the measuring instrument to determine the center line and start and end points of the ditch, and set up control piles. Transport the trench forming machine to the construction site and adjust the position and direction of the machine to align with the center line of the ditch.
3. Start the machine
According to the operating procedures, start the power system of the trench forming machine and put it in the standby state. The operator enters the cockpit and is familiar with the functions of the control buttons and the operating handle.
4. Excavation and molding
Slowly advance the trench forming machine, so that the excavated parts begin to cut into the ground. Adjust the excavation depth, width and slope through the control system to ensure that the shape and size of the ditch meet the design requirements. In the process of excavation, attention should be paid to the soil situation and the operation speed and intensity in time.
5. Finish your work
After the excavation, turn off the machine powertrain and clean and inspect the ditch. If deviation, trim with manual or small tools. Finally, clean and maintain the trench forming machine and store it properly.
The whole operation process should be rigorous and meticulous to ensure the construction quality and safety.